slag bath

英 [slæɡ bɑːθ] 美 [slæɡ bæθ]

网络  渣池; 渣浴

化学



双语例句

  1. Mathematical Model on Control of Slag Composition for Bath Smelting Copper
    熔池炼铜炉渣成分控制的数学模拟
  2. It shows that the mass contained in furnace can be divided into four areas, the mix area, carbon remaining area, molten slag area and metal bath area from top to bottom.
    结果表明,炉内物料从上至下可分为四个区域,即炉料区、残炭区、熔渣区和金属熔池区。
  3. Study on the High Temperature Region at Slag Bath Center in the Electroslag Casting Process by Simulation and Experiment Method
    电渣熔铸中渣池中心高温区的模拟与实验研究
  4. The flowing of slag in molten bath of an electric cleaning furnace has important effects on heat efficiency, the recovery of valuable metals and the life of a furnace.
    贫化电炉熔池内炉渣运动对炉子的热效率、有价金属的回收及使用寿命有重要影响。
  5. This paper describes the fluid-dynamic phenomena of the slag and matte in bath of an electro-ore-thermal smelter for copper and nickel smelting.
    讨论了铜、镍熔炼矿热电炉熔池内渣与铳的流体动力现象。
  6. The theoretical calculation equation of the height of slag splashed has been deduced by analyzing the effect between N 2 jet and slag bath.
    根据上述两种动力学机制,分析炉内氮气射流与液态渣池的作用规律,提出了溅渣高度的理论计算公式。
  7. 3D Numerical Modelling of Heating Process with Electric Arc-electric Slag in DC Electric Arc-electric Slag Ladle Furnace Bath
    DC-EAES-LF熔池电弧电渣加热过程的三维数值模拟
  8. Furthermore, the influences of slag composition and electrical parameters on the heat generation distribution in slag bath are discussed.
    在上述基础上,考察了渣成分及电参数对渣池发热分布的影响。
  9. Electrode depth inserted in slag bath was adjusted to keep slag resistance constant.
    它通过调节电极插入渣池的深度来维持渣阻恒定,以利于熔速的稳定控制。
  10. The slag temperature and morphology were measured and observed. The equilibrium between the slag and melt and the reaction of oxygen jet with the bath were analyzed.
    检测了炉渣的流动温度和岩相结构,分析了渣-钢之间化学反应的平衡状况和氧射流对熔池的作用。
  11. A oil-water model has been developed for the slag entrainment in the steel bath of vacuum refining unit with single-snorkel.
    本文针对长城特殊钢厂单嘴精炼装置进行了真空室内加渣精炼的卷渣水模型研究。
  12. The slag pool and the metallic bath are the most important two regions in Electroslag Casting ( ESC).
    渣池和金属熔池是电渣熔铸过程中两个最重要的区域。
  13. Removal of slag adhesion on surface of carburized and alloyed composite layer of graphite material by salt bath washing
    石墨材料浸渗&表面合金化复合层上的表面粘渣盐浴清洗研究
  14. Study of 3D flow field in DC electric arc electric slag ladle furnaces bath with eccentric bottom blowing gas stirring
    偏心底吹DC-EAES-LF熔池三维流场的研究
  15. Reduction of blowdown flow of boiler slag bath
    减少锅炉沉渣池排污量的实践
  16. Study on the Influence of High Temperature Region at Slag Bath Center to the Electrode's Melting in the Electroslag Casting Process
    电渣熔铸中渣池集中高温区对电极熔化的影响研究
  17. An Oil-water Model for Slag Entrainment in Melting Bath of Vacuum Refining Unit with Single-snorkel
    单嘴精炼装置真空室内卷渣水模型研究
  18. After the remelting process reaching a steady state an oxidizer ( Fe_2O_3 powder) or a deoxidizer ( Ca& Si powder or metallic Ca) is added to the slag bath by point.
    重熔过程达稳定状态后,分点加入氧化剂(Fe2O3粉)或脱氧剂(Ca-Si粉或金属Ca)。